Piston clip installation tool for C-shaped retaining rings on your moped, moped and small motorcycle.
This tool enables the installation of 12 mm piston pin retaining clips without eyelets, also known as C-clips, without causing damage to the piston or causing them to fly off.
The locking clip is first inserted into the conical part (bushing) of the tool from behind. The pin is then attached and held against the bore of the piston pin on the piston. The long cylinder can then be carefully pressed into the groove. The use of some lubricant can be helpful.
The suitable alternative for 10 mm KoBo retaining clips can be found in the accessories section.
Quality product from the manufacturer Naraku.
| Ø Pin | 4.5 mm |
| Manufacturer | Naraku |
| Material | Steel |
| Surface | burnished |
| Diameter | 12 mm |
| Total length | 134 mm |
| Area of application | (Dis)assembly tool |
Accessories & related products
Moped fans also bought
GPO 38 mm cylinder head original | Puch Maxi S, N / X30 NS, NL, N-2AH
Height: 55 mm · Width: 125 mm · Manufacturer: GPO · Material: Aluminum · Area of application: Standard · Surface: sandblasted · Ø cylinder: 38 mm · Number of fixing points: 4 pcs · Candle thread: short · Total length: 135 mm · Hole pattern [mm]: 44 x 44 · Decompressor: No
EUR 38.90
Speedometer drive 16" left with grease nipple holder
Ø outside: 42 mm · Thread type: MF10x1 (fine pitch thread) · Material: Aluminum · Place of use: left · Color: gray · Ø axle: 11 mm · 4-edge speedometer cable: 1.8 mm · Overall width outside: 48 mm · Ø mounting hole: 11.2 mm · Wheel size [inch]: 16 " · Total height: 52 mm
EUR 25.90
Hot 
swiing® ingenious "Expert" motor stand
Width: 245 mm · Height: 340 mm · Manufacturer: swiing® ingenious parts · Area of application: Motor bracket · Material: Steel · Surface: varnished · Color: red · Color: white · Ø Receptacle: 25 mm · Ø Receptacle: 35 mm · Hole spacing: 21.5 mm · Total length: 370 mm · Material thickness: 3.5 mm
EUR 88.50
Collection only possible with online purchase and appointment.
